Ben's   SP-150

                                                                                                                                                                                  l To Homepage l

Work done over winter 2009 - 2010

Working on the rear end, the swingarm is stripped out and has been away for powder coating, it will be fitted with new
bearings / seals before going back in. The shock has also been away for a re-build, the exhaust will be given a few coats of high
temp paint and a new chain will be fitted.

Exhaust all painted up

The freshly powdercoated swingarm back from Triple S. Not the best powder coating job I've ever seen,
but it's been away for a good while and we were just glad to have it back at long last! Apparently they buggered it up on the first
attempt and had to re-do it, it must have been bad because this isn't very good either. We did complain but they did now't about it

The L/H side long bearing fitted, the other side uses twin narrow bearings 

Swingarm re-fitted

Making up the new exhaust hangers that will replace the old combined hanger / passenger footpegs

Exhaust mount fitted, it just has to be painted now. Note the new Gilles rearsets and carbon hugger

This is the exhaust mount for the other side being made

Not the best of photos, but this one shows of the exhaust hangers painted  & fitted

We've also fitted a new DID gold X ring chain and a Scottooiler - one of the updated electronic ones, which was a tad expensive but it is a good bit of kit. More photos to follow soon 

In sunnier times - the SP-1 and my VFR750 catching some rays!

   To Homepage l Back to Top